» Winding & Storage Systems » Prefeeding

Prefeeding

CABLE-BUTLER

 

Compact Prefeeder
- with roller drive -

  • Pulling force: approx. 25 kg
  • Running direction: right/left - switchable
  • Dancer stroke - neutral point: variable adjustable (even above gradients of 90°)
  • The start-point setting of dancer stroke will be saved for later use after turning off the prefeeder.
  • Velocity via dynamic ramp control can be adjusted by a potentiometer.
  • 10 kg / 350 x 250 x 350 mm
  • 230 V / 50 Hz

EP-15-40

 

Electro-pneumatical Prefeeder
- with tape drive -

  • Pulling force: approx. 120 N
  • Material diameter: max. Ø 15 mm
  • Material width: max. 40 mm
  • Feed rate: 56 m/min (Basic speed via potentiometer, dancer stroke for fine control.)
  • Operation key 'FEED' for setting up.
  • Interface: for Autocut 15/40
    (Adaptation to another machine on request.)
  • 27 kg / 500 (950) x 470 x 330 mm
  • Compressed-air supply: 6 bar
  • 230 V / 50 Hz - 270 W
     

ZG-2000

 

Electro-pneumatical Prefeeder
- with tape drive -

  • Suitable for cable drums etc. with the maximum weight of 250 kg.
  • Material diameter: outside-Ø 2-20 mm
  • Material width: max. 40 mm
  • Feed rate: max. 3 m/s
    (basic speed via potentiometer, dancer stroke for fine control)
  • Operation key 'FEED' for setting up.
  • Interface: start/stop signal
  • Compressed-air supply: 6 bar
  • 230 V / 50 Hz